Asbra Safety Flooring Products Pty Ltd
Architecture in Hunters Hill
www.latham-australia.com
Address
14 Tennyson Rd. Gladesville. Hunters Hill, NSW, 2111.Are you the owner or manager of this company?
What you should know about Asbra Safety Flooring Products Pty Ltd
Whatever your project, Lat ham Pliable Mechanical Expansion Joint Covers are available and can be fabricated to almost any width or required joint movement. Tile Strips are 1800mm in length and are designed to be installed over saw cuts while the tile adhesive is in a plastic state. What are expansion joint covers worn for? Expansion joint covers are designed to hide the location that movement is occurring in structures. The expansion joint covers are installed over these areas of movement called expansion joints which are sometimes also referred to as movement joints, structural joints, isolation joints, control joints or seismic joints. Which helps reach up with a apropos expansion joint cover for a specific application. Also known as Lat ham strips, oversee strips, isolation joints and movement joints, neoprene Passion Lon, Tile and Dividing Strip systems are designed to oversee thermal expansion and contraction in constructed surfaces. To help you in selecting the correct Lat ham Step Tread losings product for your application, try our Standard Compliance Checklist, or see our product specifications. Regardless of the floor surface or finish be it stone, carpet, tiles or timber we have a product specifically to suit. Lat hams is well obvious for our wall preserve care systems and safety hand rails, and over the years these products have become synonymous with construction safety and quality. We also produce hand rail systems which donate concern to pedestrians, and reduce risk of injury and liability. We can produce abrasive infill mats for slip resistance, as well as carpeted and vinyl mats for dirt control. The preferred safety device for floor surfaces exposed to lofty levels of pedestrian traffic, Lat ham’s adjourn mounted entry mats and frames sit flush with the surrounding floor finish. All expansion joint ranges can be factory cut from full lengths to site supplied measurements if required, at surplus cost. All Covers should be installed with relevant fixings to suit the site conditions. Requires now on site work other than cutting to length where necessary. Strips should never be installed above the surrounding floor finish. Tile Strips are designed to be installed when using adhesive stationary tiling. To confirm that the location of joints in tile labor align with existing substrate joints, the tile labor joints should be constructed during installation of the mortar and tile beds, rather than by saw cutting joints after installation. Maximum difficult flooring and substrate materials above the structural base are capable to accommodate conventional levels of strain. Handle of interaction between structure and flooring materials requires coordination with the engineer to locate movement joints in the bed and tiling immediately above and continuous with structural movement joints in the base. The greatest number of anchors conceivable along this brief length of Lat ham movement joint is two. This can be cut or cast in concrete, cut into timber treads or ach
Reviews of Asbra Safety Flooring Products Pty Ltd (0)